ASTM A STANDARD SPECIFICATION FOR THROUGH-THICKNESS TENSION TESTING OF STEEL PLATES FOR SPECIAL APPLICATIONS. ASTM A A M – Designation: A /AM – 03 Standard Speci? cation for Through-Thicknes. copy of ASTM A is included in Appendix A of this report. In the process of . of a rolled W-shape that is made of ASTM A Grade 50 steel.

Author: Tajar Nedal
Country: Brazil
Language: English (Spanish)
Genre: Automotive
Published (Last): 25 August 2009
Pages: 254
PDF File Size: 10.71 Mb
ePub File Size: 8.24 Mb
ISBN: 354-4-47982-982-9
Downloads: 3951
Price: Free* [*Free Regsitration Required]
Uploader: Kazrarisar

ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Students Click Here Join Us!

Lamellar tearing may also result aetm loads on the plate surface.

Athough thickness tension test – ASTM (testing materials) Code Issues – Eng-Tips

In all cases, the minimum length of the reduced section must be as speci? Register now while it’s still free! It is also accepted that smaller diameter test specimens will tend to give greater variability to the resulting reduction in area values. Are you an Engineering professional?

Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. However, unless the order speci?

Historical Version s – view previous versions of standard. See Test Methods and De? For plates over 41?


ASTM A770/A770M – 03(2012)E1

Two tests shall be required from each quenchedand-tempered plate. For example, those nonmetallic inclusions that form during the solidi? Close this window and log in. The joining method used shall be one which results in a minimal heat-affected zone in the portion of the plate to be tested. Posting Guidelines Promoting, selling, recruiting, coursework and q770 posting is forbidden.

ASTM A A M_百度文库

Within the text, the SI units are shown in brackets. This minimum value may be from 1. A minimum slenderness ratio of 2 was selected for the standard Type 2 specimen to allow a 0.

To improve the through-thickness ductility and thus the resistance of the steel to lamellar tearing, it is necessary to reduce the level of the nonmetallic inclusions. Because these relationships between the test specimen diameter and the average and variability of the test result have not been satisfactorily quanti?

Last previous edition approved in aastm A — 86 For Type 3 specimens, locate the weld fusion line of one plate surface within 1? Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

Over a minimum plate thickness determined by the specimen end con? It is informational only and not astj official part of the standard; the full text of the standard itself must be referred to for its use and application.


Within the plate thickness dimension speci?

Several types of test specimen shall have specified values of plate thickness, diameter, minimum radius, and length of reduced section. Digital Transformation may be defined in a number of different ways by analysts or enterprise software vendors.

Within the text, the SI units are shown in brackets. Resources Digital Transformation may be defined in a number of different ways by analysts or enterprise software vendors.

It is generally accepted that there is a diameter effect on reduction-of-area values such that a smaller diameter specimen generally yields a higher average reduction in area value. Location of Test Coupons S5.

The number of tests and test positions have not been established that would provide a good estimate of both the mean and the variability of through-thickness tensile reduction of values of a plate. This abstract is a brief summary of the referenced standard.

It does not refer to the condition of the plate. The principal purpose of the testing is to provide a measure of the resistance of a steel plate to lamellar tearing. Current edition approved May 10, Some of these factors are discussed in X2. A Test Methods and De?

Author: admin